Elevator Forum

This version Attachments 875C9E8E-0D63-4820-997E-097C38A76665.jpeg (254.4 KB, 37 downloads)

Thanks for the reply 🤙🏻 I have most of the MX-GC stuff this one is abit newer with a touch screen I’ll post a photo

Hello bojan,Yes I have tried a 101 reset, have even plugged in installation shorts to drive on the LDU pendant, to no success, removed LEUT to bring t...

Done this to no avail, Schindler came in required a software update Last edited by Chrisbzzz; 09/08/20 09:11 PM.

Are you still looking? PM me your email address

Hardware fault on the Drive replaced board reprogrammed parameters to drive lift all good now Last edited by Chrisbzzz; 02/16/19 11:35 AM.

It’s a yaskawa Drive I’ve been told you it has to see certain mags in the shaft for it to perform a learn run I have tried this when I go into 5-2 it ...