Elevator Forum

I didn’t think any of my readings seemed right. I am sending CPUA board and IOD board for repair. I will update when I get them back. The help is very...

I have 88.9 ohms on CCL to CCH with connector off on IOD board. With wires on it is constantly changing. I checked it at the CWIL board with it discon...

It’s in US and it was installed in 2005. How do I get the software?

I’m in that section. It’s section 7 for me. How do you active a certain floor? I’m only wanting to shut off the top floor. I have the infant pos 1 set...

Where do I get the HHT tool?

I have a group screen but nothing is showing up on it. Yes I have prints.

So I’m back out here messing with this. I have found that neither the up or down hall output boards the light stays on. I can see the outputs on my la...

How do I know if I have a level 4 tool? I have a laptop from kone that connects to it.

Each car has the miprom overlay and they both have the cpu, pio and sio boards vertically. It has the card rack in a separate controller underneath