Elevator Forum

Originally Posted By: jj5phil I worked on a similar controller a few years back, for some reason I thought it was A CJ Anderson controller. We may sti...

There should be a metal template on the job for setting the interlocks. I've found that the guys in construction are not setting them properly and it ...

If you adjust the valve you must do a decal learn. On machine room inspection, set the car at the bottom with 30, 77n and 61u lit on the cpu. Go to 5-...

Correct answer. I've worked on a few of these. NOT the best product I've ever seen.Originally Posted By: jj5phil I think that's the slack cable switch...

I have two, I'll sell one cheaper than that.

We simply take callbacks. The company is all about money money money. One of our guys opened the door on a Miprom 21. He said he saw the puddle of wat...

I have two of them at the house. Do you know the kone part number?Just looked at the picture in the gallery. I have two of them, still in the Styrofoa...

Do you have a part number for it? I have a couple in a spare parts bin at the house.

I can only assume this member is no longer here. I can say that I do see what he is referring to as far as the industry and the online forums.

What you guys have mentioned is what I've always done. We had an inspector write up some cars during his annual walk and said they should be open duri...

That's what I'm wondering. Micelect is crap. It will not maintain a consistent reading. Looking to replace it. I'm sure someone has ran I to the crap ...

One way to find this is as follows......turn off all of the cars, power up one car and see where it goes. It should go to the floor with the stuck but...