Elevator Forum

thanks guys it wound up being a bad tacho on the motor

well the tach was finally the problem still will like to get some paperwork on this if anyone has it thanks

can anyone help???keep getting a "bf" and "sf" fault are these brake and speed fault? i would greatly appreciate some help

mowery relay logic or solid state? if this is relay logic mowery then the voltage is 120vac which is powered thru term a and x3if this is solid state ...

that kinda looks like a century controller

just a side note i would also check that the proper grade of brush is in the genny as some gennys are very sensitive to this

well scott i know of someone who lost a finger using this tool ... when he went to open the bottom floor door he did so to quickly after the car took ...

i use the world freedom tool and it works rather well

i believe they were installed in 1999 and no there is no transfer switch but if "d" car is shut off the other is running as a simplex so it has no eff...

i use the ims tool and it is very good for tac 50 or 20

hey rich i would like prints on a dmc 1a and 1m also valve adjustments if u can help.......thanx