Elevator Forum

the older gen 2's yes but the new ones no sorry it will not talk

i don't have my book in front of me but car 2 is most likely your "master" and car 1 is the "slave" when you have to shut down car 2 you might have to...

i don't know anyway of doing it with out some type of service tool.

I do mine pretty close to elmcannic, you must must must down load the clc info or you will be very unhappy!! i just get control of the car and have th...

i just replaced one on a car. had a hard time finding a company that could make one/supply one and you had to buy a 10 foot piece also a long lead tim...

did you replace both boards on both jambs devices? i had a similar problem with a hall button in a group and it was a the other hall station that was ...

Your employer should be able to get that info and the key for you.

word on the street is that MCE and GAL are putting 10 year caps on there controller components?

do you have magnets on the back of the tape? if so make sure they have NO spacing between them. i have had issues before. also take out the little ice...

are you talking about gds/gd2? you need to reset unintended motion. or you lost the brake switch.

only on a carnival ride

we can fight over who presses the call button!!

get the job number and call otis they are very good at getting you the prints.

oh i got a good one for preventive maintenance..... old otis ucl 1960ish, the wires from the controller to the generator insulation got so old and bri...

MCE is the one i like the best....great product that just about any company can walk in and work on. tech support and parts are easy to work with and ...