Elevator Forum

Which board are you using , they make a few different versions. Are you sure you are using the correct door motor voltage?

Just an update, WE tested the power relay board and it checked out, the CLC had some bad communication chips. Running well now.

Atif; Give them a call, it takes a while to get a call back but there tech support is very good. What problem are you having?

If you have the NG-12 controller, I have a set of prints. They are '99 , I don't remember when they switched to the better controller.

We have been using them for years. (Savaria actually has it as an option now for their Lulas and Chairlifts, they are junk) . We do use a crane contro...

Originally Posted by heisenberg Also have you checked the counterweight buffer safety switches? They may need to be reset I'll stop by and double che...

Originally Posted by heisenberg You've done a single reset? Refrain from doing a double reset guilty, did multiple resets.

The door operator is some homemade contraption from NVOV. They are using a Dover clutch and pick up rollers, but the operator is a belt driven 9VDC (N...

When you are working on it, remember that there are two different IBM relays on the front, you can't swap them with each other. Also when you reseat t...

The code says a max of 6' of flex, not a min. But that can be circumvented by a junction box. While it looks bad, nothing wrong with the runs. The one...

The covers meets the 14 ga. thickness required for a fire rating. The frames had to be relisted to include the openings before they put them in the fi...