Elevator Forum

We did one so far to replace the obsolete Schindler motor and VF drive. We kept all the mechanical schindler/ECI components and just replaced the door...

Did you try Adams? They have been advertising that they can sell direct software upgrades now.

It's still on their website. It's pretty rare that you even need a tool on these. Probably some of the most reliable hydro controls made in my experie...

Are you sure your not referring to Vertitron Midwest Controls? They used what was called a P.E.T tool on their earlier controllers. See bottom page of...

I’ll see if I can get some info off the tag, but it is all relay logic and I believe they called these Otis “Slim line” controls. Last edited by AB...

I saw an ad in elevator world that Canton makes one now too.

Did you change the hydraulic oil out when you changed any of the motors?

Did you check with Vertitron? They still sell some of their older boards or will often repair the boards they don't sell anymore. http://vertitron.com...

World electronics should make a new replacement or could repair the existing board

If it is the power supply board I would send it to ECI (electronic controls Inc) in Fl or Access Electronics in MD for repair. Buying these older Conc...

I believe ESI (elevator sytems Inc) in NY typically built the controllers they used other wise I know Custom elevator supports their residential stuff...