Elevator Forum

Unfortunately the only heller prints I have are for a m/g job, a single spped AC and a hydro. Being Westinghouse bought Heller back in the day, maybe ...

A 2 speed AC?

Is it a m/g job?

R&O was a company out of Minneapolis that was started in the 1920s. They manufactured a lot of their own elevators in house and in the later years...

From the pictures I can definitely say that is a Access lift. I think your right about somebody simply adding a Concord capacity plate. To get the pri...

Just out of curiosity has anyone else used a galaxy hydro controller? If so, how do they compare as far as price, being installation freindly,and rela...

I beleive Northern sets those up at the factory based on your job conditions. That is why they typically ask for a job number for theses boards before...

Hahaha from the sound of it, it didn't go so hot for the maintenance man. Probably thought he was going to save a bunch of money. We usually figure 6-...

Concord and Access Industries were two different companies. Access was bought by Thyssen and Concord was bought by Savaria. It can only be one or the ...

I dont have a lot of experiance with this equipment but we did have the exact same drive go bad on a Garaventa. In my area Garaventa will only sell pa...

We had the same thing happen on Montgomery/Kone pump unit. It was a non serviceable enclosed muffler in the tank that came apart internally and pushed...

I'm not sure there is such a write up but if its the lift I'm thinking of and the rollers run in a buried channel, there are only two pain in the ass ...

Here is a couple videos on Vertitron doing them: