Elevator Forum

The thermal overload is typically mounted either on the submersible motor itself or very close by under the oil in the tank. It would be fairly easy t...

Never try to clean the screen on your up leveling adjuster On the I2 and I3 valves...just replace it. The screen is too fine to accurately clean. A di...

You will need a tool to program the PI. Also if that soldered on battery goes dead and you loose power it will dump any PI, door times and security se...

I would second the soft start. No contacts to change, won't mechanically hang up, more energy efficient and relatively cheap insurance for the custome...

Another issue can be the little sheaves that run the selector cable. Bad bearings or a worn sheave can cause the sheaves to move around causing incons...

Talk to these guys: they still support the obsolete Baldor elevator drives.

looks like a GAL VP SST series button. They have different part numbers depending on lamp voltage.

It all depends on what company and what department you work in. Some companies might have more than one office within a local. Also if you work in the...

The TAC50-04 and for that matter any of the Tac stuff can be considered "non-propitiatory" if the job was ordered with owners IMS which will only work...

TKE was using vegetable oil about 10 years ago and had all sorts of problems with leveling due to the fact that the veggie oil did not respond well to...

I would second JustWolf and would recommend adding small nylon set screws to the sleeve so it keeps it from clanking around and also so it won't damag...

Did you try World, ECI America or Access Electronics?

The 330A has a on board diagnostic tool on the CRIPHNA board so a separate tool is not needed for trouble shooting and adjustments.If you don't have a...

Those look like CJ Anderson buttons to me.

We had a building owner ask for pricing on replacing the belts on a 3300 and the unit was only 4 years old. They had an oil and grease contract with S...