Elevator Forum

Notifications
Clear all

TAC32 Question

7 Posts
6 Users
0 Reactions
4,394 Views
(@wltr00)
Honorable Member
Joined: 17 years ago
Posts: 359
Topic starter   [#36054]
Have a bad PA door board & Vertical Express wants to replace it with an LD16 Operator as they no longer make or stock the PA door boards. Anybody got any experience with this? Any issues?
Thanks



   
Quote
(@mrgrinch)
Active Member
Joined: 17 years ago
Posts: 13

   
ReplyQuote
(@wltr00)
Honorable Member
Joined: 17 years ago
Posts: 359

   
ReplyQuote
(@tayto)
Trusted Member
Joined: 17 years ago
Posts: 70
 
Yes! have the same dilemma currently on a TAC20 (6300PA3). TK still makes the boards but there is a world-wide chip storage, so any boards they do have they are not selling to outsiders. you can try to get board repaired but the success rate is only 50-60%. i think the LD-16 drive kit upgrade is the way to go here depending on controller. at least you can buy parts from Wittur or Kone..

Last edited by tayto; 10/05/23 01:21 AM.


   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
Keep in mind that you’ll still have to get the 2 boards from TK. The CAN interface board and the main board because it has firmware in it you can’t get from Wittur to be code compliant.
Going to an MOVFR or MOVFE isn’t a bad option if you have an open discrete port and at least 6 spare travel cable wires.



   
ReplyQuote
(@tnhapa84)
Trusted Member
Joined: 17 years ago
Posts: 60
 
Here is the chart for door boards , Vertical Express sent this
Attachments
D47CEB87-1ED3-4F82-90C4-B3AF5C6A1C8A.jpeg (451.08 KB, 57 downloads)



   
ReplyQuote
 JJR
(@jjr)
Estimable Member
Joined: 17 years ago
Posts: 223
 
I think the LD-16 (Wittur product is your best bet as they are engineered specifically as direct replacements for the old Miami Elevator/Early TK door equipment. I'm also a grinch of harmonic operators. They are just too outdated and have too many moving parts. If you wanna go cheaper, GAL has a direct replacement linear product where the only thing you'll need to replace is the operator itself. You will be able to reuse other existing components, such as the skate and hanger roller/tracks. It's called OMNI. Just like LD-16, there's no limit cams/switches to deal with. If you've been having difficulties getting parts from VE/TKE, the GAL product is your best bet. It might be easier to source parts.

LInk: https://www.gal.com/wp-content/uploads/2023/08/GAL-MONXT-OMNI-Telescopic-Linear-Operator.pdf

You could also get a Glide-A (or P) from Otis.



   
ReplyQuote
Share:
Scroll to Top