Notifications
Clear all
Topic starter
11/02/2017 12:53 am
car is found shut down level at bottom landing. 3 stops. front only. go to plug in with hht. car starts up again. goes into viscosity control. and is ready for action. usually the call comes in on monday. i tried recreating it. hit the manual lowering and it relevels no problem. cleaned the levelling sensors and mirrors. checked the power supplies. all where they should be. has anybody had this problem with these wonderful controls?
11/02/2017 3:28 am
What is the shut down code ?
11/02/2017 5:03 am
What type of valve is on it? Have you cleaned screens?
Topic starter
14/02/2017 4:06 am
eeco uv5a valve. screens are clean. no logged faults.
14/02/2017 6:34 am
Does job have a tank heater??? It sounds like a viscosity problem.
Last edited by Rolly; 02/13/17 10:34 PM.
15/02/2017 10:04 pm
Did you put a gauge on the valve, pull the main line and shut the gate valve in the hydraulic line?
Topic starter
03/03/2017 1:49 am
i found the lu and ld sensors too close together. so i spread them to the factory reommended spacing. then it was stopping early in the down. the valve was set to glide into the floor. now i have stabilized levelling and a firm stop. i installed a tank heater too. im not sure which of those two items fixed it. but it hasnt shut down for over a week now. which is a new record. its been this way for 10 years. but the site caretaker had been resetting it for years without our knowledge. now hes gone. i hate when people dont follow up with what their fix was. so i figured i should. maybe it will start to become the norm around here.
03/03/2017 2:01 am
Thanks for the follow up!