Elevator Forum

KONE MUL Board Repl...
 
Notifications
Clear all

KONE MUL Board Replacement

11 Posts
5 Users
0 Reactions
12.3 K Views
(@truegrit2)
Eminent Member
Joined: 17 years ago
Posts: 16
Topic starter   [#29042]
Ive got a KONE acting up with a 048 fault. I got here by trying to toubleshoot RIFF board (phone not working) by swapping it out with adjacent car. After swapping board, elevator goes to nearest floor and holds door open (fault 48). I thought i may have messed up the cable between RIFF and MUL but have tested and seems okay, which is leading me to believe the MUL is bad?

If MUL replacement is needed, do i have to reprogram the COP?

Thanks!



   
Quote
(@dmhughes)
Trusted Member
Joined: 17 years ago
Posts: 81

   
ReplyQuote
(@truegrit2)
Eminent Member
Joined: 17 years ago
Posts: 16
Topic starter  
Thank you Dmhughes. I double checked that the small red light is going off and back on when i break the plane. the edge plugs direcly into the operator. is there a better way to check?

Thanks!



   
ReplyQuote
(@lowoil)
Reputable Member
Joined: 17 years ago
Posts: 270

   
ReplyQuote
(@dmhughes)
Trusted Member
Joined: 17 years ago
Posts: 81

   
ReplyQuote
(@truegrit2)
Eminent Member
Joined: 17 years ago
Posts: 16

   
ReplyQuote
(@dmhughes)
Trusted Member
Joined: 17 years ago
Posts: 81
 
If it’s not the input from safe edge it maybe a faulty D/O button, it’s stating that they’re open device is triggered?



   
ReplyQuote
(@kone89)
New Member
Joined: 17 years ago
Posts: 2
 
put the lift on fire service inside the car, if the doors close normal on fire service you have a Photocell fault. Sensors/cables/board for the sensors could be faulty. 0048 is photocell or door open button i highly doubt you have a faulty MUL Board. Also you dont need to do a LON download when changing the photocell board.



   
ReplyQuote
(@e-man)
Honorable Member
Joined: 17 years ago
Posts: 480

   
ReplyQuote
(@truegrit2)
Eminent Member
Joined: 17 years ago
Posts: 16

   
ReplyQuote
(@truegrit2)
Eminent Member
Joined: 17 years ago
Posts: 16
Topic starter  
Quick update: detector and DO button are okay... all associated boards, cords and programming turned out okay. The problem was dip switch 1 (force LIM A) set to ON, on S! on the cartop LCECCBN2 board. 048 fault all day.

Thanks for your help!



   
ReplyQuote
Share:
Scroll to Top