Elevator Forum

Check the controller to controller group wiring.. there's typically a SOM, switch over module in each controller, which allows controllers to apply po...

Try removing and re-installing the pulse jumper bars and reader unit (each end of the belt). Ensure good condition of sharp points inside shorting blo...

dang, they're never in the machine room next to the dock are they! Good luck!

Quick update: detector and DO button are okay... all associated boards, cords and programming turned out okay. The problem was dip switch 1 (force LIM...

I just repaired two of these... I could find no coils available commercially but had great luck rewinding them at my local motor shop. tip: take the e...

I'd have an interest... What would you want for them and where are you in the world?Thanks!

Thanks all! I'll be back onsite tomorrow armed with a few good leads! Much Appreciated!

No Sir, Just the 048

Thank you Dmhughes. I double checked that the small red light is going off and back on when i break the plane. the edge plugs direcly into the operato...

Sounding like you've got a good plan here... I'd say Smartrise is always a good option because the boards are the same and interchangeable between the...

this programming guide is available and free from KONE Spares.. just call and ask