Elevator Forum

Kone MonoSpace over...
 
Notifications
Clear all

Kone MonoSpace overtravel

7 Posts
6 Users
0 Reactions
8,361 Views
(@heisenberg)
Reputable Member
Joined: 17 years ago
Posts: 280
Topic starter   [#20866]
Hey Guys,

Been having issues with this kone Mono Space, which has been running fine for roughly 2 years, until recently it has been over travelling at the bottom, trapping passengers.

I haven't replaced any of the leveling pencil magnet switches.

Once the lift is reset, it will run fine with no issues for around 2 weeks, and then happen again.

If any kone gurus has delt with this issue before, any support or ideas would be greatly appreciated!



   
Quote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729
 
Traction relation on MX machines is horrible. Lower Accel/Decel rate and see if fault disappears. In other words make it drag into floor a little slower.



   
ReplyQuote
(@heisenberg)
Reputable Member
Joined: 17 years ago
Posts: 280
Topic starter  
Originally Posted By: Rolly
Traction relation on MX machines is horrible. Lower Accel/Decel rate and see if fault disappears. In other words make it drag into floor a little slower.

Thanks for the info!

With adjusting accel/deceleration, do I need a kone hand tool? These lce boards are usually locked out and difficult to adjust.

I have a LCE parameter manual



   
ReplyQuote
(@alex75)
Estimable Member
Joined: 17 years ago
Posts: 130
 
Sounds like the tacho needs to be cleaned.
It may need a new setup run after that and for that the LCE controller must be unlocked?
Do you know what software version it runs? (its printet on the software eprom)



   
ReplyQuote
(@chicago)
Estimable Member
Joined: 17 years ago
Posts: 120

   
ReplyQuote
(@lowoil)
Reputable Member
Joined: 17 years ago
Posts: 270

   
ReplyQuote
(@travator)
Trusted Member
Joined: 17 years ago
Posts: 35
 
Is it traveling to the first floor or trying to leave the first floor? Had a LWD issue one time causing rollback which would hit a limit when trying to leave first floor.



   
ReplyQuote
Share:
Scroll to Top