Elevator Forum

Notifications
Clear all

Kone monospace 0072

20 Posts
8 Users
0 Reactions
14.4 K Views
(@liftboy1)
Active Member
Joined: 17 years ago
Posts: 12
Topic starter   [#34951]
Hi All,

New to forum. I work in Wales in the UK. I have a monospace giving me 0072 and 0083 every day, I am having to call in to reset it with a power cycle. I have changed all pencil switches and ado PCB. Anything I am missing here?

Thanks in advance



   
Quote
(@jadam)
Estimable Member
Joined: 17 years ago
Posts: 110
 
Hi
If it is an LCE controller, you must check your 61:u sensor (error 72) you should probably make a new shaft setup, menu 5-2-1 (error 83)



   
ReplyQuote
(@liftboy1)
Active Member
Joined: 17 years ago
Posts: 12
Topic starter  
Hi Jadam, yeah I have changed that on 3 occasions. Carried out a new shaft setup as you say today. I was thinking possibly taco?



   
ReplyQuote
(@dmhughes)
Trusted Member
Joined: 17 years ago
Posts: 81
 
Hi,
Could be the CCB board, I have had one of these intermittently not responding to the pencil switch inputs? Might be worth a try?



   
ReplyQuote
(@liftboy1)
Active Member
Joined: 17 years ago
Posts: 12

   
ReplyQuote
(@dmhughes)
Trusted Member
Joined: 17 years ago
Posts: 81

   
ReplyQuote
(@liftboy1)
Active Member
Joined: 17 years ago
Posts: 12

   
ReplyQuote
(@dmhughes)
Trusted Member
Joined: 17 years ago
Posts: 81

   
ReplyQuote
(@liftboy1)
Active Member
Joined: 17 years ago
Posts: 12
Topic starter  
Looks like my adon download didn't work as lift gone down again today. Will replace CCB and let you know.



   
ReplyQuote
(@liftboy1)
Active Member
Joined: 17 years ago
Posts: 12

   
ReplyQuote
(@dmhughes)
Trusted Member
Joined: 17 years ago
Posts: 81
 
That’s a crapper mate, I’d be looking at cpu next? I know it’s a lot of messing about but what else is there? You seem to have exhausted everything else 🤦‍♂️
Please keep us updated on the problem, good luck 🤞



   
ReplyQuote
(@john-jay)
Prominent Member
Joined: 17 years ago
Posts: 798

   
ReplyQuote
(@liftboy1)
Active Member
Joined: 17 years ago
Posts: 12

   
ReplyQuote
(@heisenberg)
Reputable Member
Joined: 17 years ago
Posts: 280
 
I a issue similar to this, the problem was caused by the EMF being produced by the motor, causing the cigar switches to change state.
I relocated the switches to the other side of the car and it fixed the issue.



   
ReplyQuote
 MX4
(@mx4)
Estimable Member
Joined: 17 years ago
Posts: 226

   
ReplyQuote
Page 1 / 2
Share:
Scroll to Top