Kone ecospace floor stop tuning

Guest · 2012-05-10T22:00:00Z

Hello, friends! So we got this Kone MX20 PMSM flat motor removed, rewound, re-installed, set the resolver angle, polarity, tach polarity, did a shaft learn, adon learn, and this thing now runs on automatic, to all floors! Hooray! Thanks to all of you, my friends! Only thing is this, when it comes to a floor, it levels in normally, then it comes to an accurate stop normally, then the c/o doors open up. All good so far. When the doors are about 3/4 the way open, you can hear the main brake set- "clunk". (Is that a selling point?) Anyway, very typical, and all good so far.But, after the main brake sets with that characteristic "clunk", the then car drifts up about 1/2". which is about 12 mm. No bueno. It stops, but only after it has drifted up. It must stay at floor level, after the brake sets. We are re-adjusting the brake shoes, looking for .004", which is roughly 0.1 mm. We are checking the loadweighing. Any other ideas? Thanks in advance! Last edited by Vic; 05/10/12 10:04 PM.

Page 4 / 4 Prev

Technical Questions

Last Post by Anonymous 1 week ago

46 Posts

1 Users

0 Reactions

114.8 K Views

RSS

Elevator_Steve

(@Elevator_Steve)

Joined: 1 second ago

Posts: 0

18/05/2012 11:27 pm

The problem with the drive aside...Huge achievement getting the MX machine rewound and bearings done!! Bravo on that, it opens up options for everyone.

Cheers

ReplyQuote

Page 4 / 4 Prev

13 Forums
7,385 Topics
41 K Posts
1 Online
1 Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed