Elevator Forum

Glide A Door Op Upg...
 
Notifications
Clear all

Glide A Door Op Upgrade

21 Posts
7 Users
0 Reactions
4,818 Views
 MX4
(@mx4)
Estimable Member
Joined: 17 years ago
Posts: 226

   
ReplyQuote
(@chris-mei)
New Member
Joined: 17 years ago
Posts: 4
 
Where do I get a signal from the glide to supply the dso that the gcs controller needs. Fso is front safe ooen correct? If so, will this supply the dso signal?



   
ReplyQuote
(@tayto)
Trusted Member
Joined: 17 years ago
Posts: 70
 
Aside from going from 110vdc to 220vac, it should plug right in to the integration board. It is multidrop not discrete., it is a very straight forward swap.

Last edited by tayto; 03/31/26 12:50 AM.


   
ReplyQuote
(@chris-mei)
New Member
Joined: 17 years ago
Posts: 4
 
The glide has a dol wire. The gcs controller doesn't have a spot to land the wire. The at400 is sending a dol signal to the gcs controller that shows up in the parameters, a signal from the encoder through what wire though.

Last edited by Chris MEI; 03/31/26 04:25 PM.


   
ReplyQuote
(@tayto)
Trusted Member
Joined: 17 years ago
Posts: 70

   
ReplyQuote
(@tayto)
Trusted Member
Joined: 17 years ago
Posts: 70

   
ReplyQuote
Page 2 / 2
Share:
Scroll to Top