Elevator Forum

I sent it to you.

Dear Jadam,It happened mostly when Normal mode down direction, INS mode UP and Down was fine. I have increased C1-01 to C1-08, but no effect (1.5-->...

any error logs showed?

Thanks a lot Rolly

PM me, please

please find the attached pictures Attachments load sensor.jpg (2.81 MB, 35 downloads) GAA30762_edit.jpg (99.21 KB, 38 downloads)

Load weight calibration could not do because 4 pad sensors were damaged and got calibration missing sensor during calibration, then LoadW type I set 0...

seem no command from the controller to drive,, please check output the TCBC or GECB

hello Pjalle,I have not checked yet about the 0 value of Bucher Valve, could you advise me how to check this, pleaseI have checked the 0 value on para...