Elevator Forum

So, I came back this AM with a clear head and a confidence that my limits were fine and I finally found that I was getting my OD output and my OD cont...

Pieman, you were right on the money. I was able to go adjust the inertia setting on the drive and issue went away. I was able to prove it out by decre...

This is a mod job. It has a TK machine and governor. Otis replaced the motor. I believe I am losing MCSS because I have watched it drop in the handhel...

I didn't try a new learn. Have never done one with Otis handheld before. Was afraid to lose my floor table and be completely screwed. At least right n...

Yes. Reset has been tried. Inputs appear correct. 11 never goes away. GET command returned an OK

I finally got this car running. Had a bad CPUA board. My SPC was good but the CPUA did not recognize it, therefore wouldn't turn on my SAFCPU / M outp...

I now see that EGOOD EBAD is for my ETSD. This has no terminal slowdowns so it would not be used because its a hydro. I think I have a bad I/O on my C...

Yes. I ran the command, but it tells me I have to place a jumper on JP7 and I can't find it. Also, does anyone know what the EGOOD and EBAD Light mean...

Thanks for the help. I did a similar procedure to get mine out as well. It was mounted in a closet with "no" room on either side so it was a ton of fu...