Elevator Forum

Afternoon,Thank you for the response,I am getting a 108 fault with sub code 2009, when it faults that is the only code. The car is 150fpm, 4000 pounds...

Thanks for all of the input, I know that this is a late post by I ending up replacing the drive with a regenetive drive and it has solved the issue. T...

The drive was swapped and the same escalator that runs in the down direction still faults out with a over speed fault telling me that it has something...

Thanks for everyone's help, I was able to get in contact with Ecco and get the literature that I needed in order to default all of the adjustments and...

The drive was swapped with the unit next to it but not the resistors. There are four resistors that total up to 27 Ohms, the resistors read the same a...

There is only one Ac drive controlling both motors, there is a motor on the left and on the right of the gearbox. The motors are in phase with each ot...

I do not believe that it has screened ports, I could be wrong though i am not too familiar with this valve.

I've got the car to level up with a soft and stop and doors opening on pre-level but now the up transition is very harsh, I tried adjusting the transi...

Here is a link to a picture of the valves. [img:left][/img] [img][/img]

Thanks Rolly and everyone who responded, I will check the condensor timing on the valve coil, the pump is coasting to a stop. This might be a silly qu...

Thank you for all of the responses, sorry for the late response, it is an Otis controller, the elevator stops level with the floor, its just avery har...