Elevator Forum

Originally Posted by Indirtwetrust Sounds like it’s heating up the oil. Just make sure they stop when it gets to the viscosity temp setting. That wou...

Originally Posted by solidstate We have had good experience with both Claddagh and Electrrodyn. I’ve had very good experience with Claddagh’s DLM uni...

Where are you located? As far as installing, I think it’s best using a somewhat local manufacturer so that you can easily get parts and support when n...

I’ve personally had more callbacks and issues after Argus installs. What I don’t like is that all the contacts are internal. If you have an issue (bes...

Update: Replaced the auxiliary sensor board on the selector and car is back up and running.

In case anyone referenced this post, I got the car running. One of our power supply was only putting out 3.7vDC on our 5vDC output side. Adjusting the...

Thank you, I just sent you a PM

Thank you both, I appreciate the reply!

I don’t know the up speed off hand but Adjustment 2 was set to 90 (adjustment 1 was set to 90 as well)