Elevator Forum

hmm not sure, usually just use the tool, not the onboard interface. sounds similar, except the tool says PF power failure ram reset. and onboard says ...

SPT secondary postion transducer. loss of SOK input to mlb3 board. MLB3 board supplies 24 volts to cartop SPT unit. the wiring of the unit then sends ...

did you try a pf ram reset m151? had a car gong that would not turn off, went down the same road as you replaced boards etc. same thing did a m151 and...

maybe this car has nudging enabled, and the other cars do not. check that out. you can always disable nudging, and when the problem happens, the doors...

motor field connection problems, vp 13 or vp32 both motor field problems. maybe a bad motor field connection, or bad field feedback board.

vertical express was 800, then they went down to 360. i just bought some and they were 150 bucks that was the price last month. just fyi. before the p...

Echelon LonTalk PCC-10 Model 73200R Network Adapter PCMCIA Card 73200 NEWtry eBay thats where i have found a few, some come with cables. echelon no lo...

somewhere in between

like screen name B69T69 i wonder how many know what b69 t69 is ?

don't think you need DOZ to get the car to run on automatic. probably something else .the power supply molex connector can be a problem, make sure all...

don't think you need DOZ to get the car to run on automatic. probably something else .

i must have only came across older software on the dmc, i have tried giving various jobs over the years, car calls from the tool, and nothing. I proba...

thanks idwt we do have the manual, good advice, will do.

good call guys, if you look closely at the parameter listing, for 52 and 56, it does say in the table floors served,, 2 which would be a value of 2, b...

when it its in the failed condition, did you try entering the GET command and see what the response is? sound like you may have a cpu, or eeprom faili...