Elevator Forum

are you sure ground is the common? . 170 VDC is a strange reading for a controller power supply, My print shows 112 as the common, and most likely the...

just cut the blown capacitor out, i usually just scrape the board with a knife between the capacitor to clear the short, then replace the r58 resistor...

have a print that shows that T2S n/o relay contact, or sr1a diode would be the problem. these are the only items in line with 1A coil that would cause...

its been awhile, but i believe there is a reflective tape at each floor for the door zone. Have you checked to see that the dz input is good, maybe so...

are you able to look at the lu and ld signals? you can go directly to the floor control board and look at the bits, or you can go to the display secti...

we have been using the Pixel system from EC for all our mods, up to 500 fpm , and up to 15 floors so far with no problems. they are insisting that the...

do you have the info from the controller? drawing number if so pm me your email, i can get you something. also, can get a relay board if you need.

just being inquisitive , speed is definitely a concern, i think I'm more concerned with the positioning system at that hi of a speed. i just don't thi...

well this post has had over 100 views, and no reply. I guess the only ones that have installed cars this fast and this many rises are the big guns. ki...

tac 50 with card rack of pmi boards etc. not sure of the outcome, i have not heard back from him think he went on vacation, ill have to remember to ch...

remove jumpers from row 0 pin 3 or 4 on the personality board. far right pin of the row is 0, if pin 3 or pin 4 has a jumper then car will park at flo...

you did mean that you "borrowed the laptop with IMS on it" didn't you? wink wink. there is quite a bit of info in the Help drop down menu, on the main...

easy mistake to make, mistakenly adjusting parameter 0, which is Max speed close, not Hi speed close. so if you adjust parameter 0 below the value set...