Elevator Forum

i believe solid is correct, if you have downloaded the lon config files, and car parameter/io files, you should be able to install the new cpu and upl...

what is a o&k 301 computer? what is it used for

are you sure that ims will work on all t3 controllers? have you tried just curiousthought you could only use hyperterminal or similar program

i know someone has logged into the drives, because the password for the drive is in all the controllers. drive password 0000 but when i plug into the ...

update, car is running, I did the drive calibration, and still the same problem, i then adjusted the current loop balance per the instructions, by adj...

Yes. Dzu is up. Hey jay i have some literature but if you could get me a few pages of what u have that would be greatI have not come across what you d...

well replaced the drive power supply with one i found on eBay, thanks jkh, this took care of the hard fault #9 and # 24, unit boots up with no errors ...

that was a problem, working on relay dispatchers is tricky business, i have not worked on them in 20 years, and my memory is fading, one thing you cou...

thanks everyone, nice manual jkh, and jk i did find a power supply on eBay for 225. one of the other cars has a power one power supply that was wired ...

Drive box says spectron. All allen bradley parts insideDid figure out that the +12 v power supply is only 10. All others okMaybe this is causing drive...

those are tough prints to read, especially the common panel. you are going to have a tough time without job prints, the ones i sent you are generic, b...

i have the Kone hand held tool. went back to the job, checked up and down speeds, the up and down hi speeds are about 15fpm off, slower in the up whic...

if it is tac50-04 are u using the ims cpua program?

jkh ill check on that dynamic braking circuit. something to think about. thanksjay, thanks for the input. i did check min pos err, it was the same as ...

Ok. Checked msu info screen jay. All good there. I decided to do a learn run any way. Strange outcome. Car now works fine in the down direction comes ...