Elevator Forum

How large is your dead zone setting?

I'm not sure, I was only on job for a short time. It is linear power door operator maybe an esi

I know this is an old thread but would love to hear more people's experiences.

Did you also install the version of safety A software? Is this a gearless machine? If so with changing the ppr in the speed loop you may have to chang...

Anybody??

Those two landing systems have different ppr, you have to change it in the configuration file.

LF67 & 68 are the drive load weighing offsets and gain

Sounds to me like it's a pmac so the motor rpm isn't critical only at start up. You have to go through your load weighing adjustment procedure, small ...

Do happen to have model numbers of both governors? We have a 500fpm job doing the same thing.

How do you have different voltage on a1 and a2? Where are you taking measurment from? If you have motor field voltage and voltage across armature car ...