Elevator Forum

So we did adjust gearlash, that had minimum improvement. The vibration is a high frequency. I also turned off inertia, the vibration would go complete...

Kinda what I'm thinking, but need to verify.

Originally Posted by mbke You have to REPLACE DL MARTIN jacks. The pistons diameter believe it or not get smaller through the heavy pressures . This t...

I have several.

The Eprom chips have gone bad

I would have to disagree on the plc based controllers. How much experience do you have working on them? The positive thing about them is that your not...

Originally Posted by Tramguage1 Yes sir, only advice I can give is do as much as you can to get your name out there. Most customers don't know there's...

Is there room to install another set of rails in rear of hoistway? We converted one to a cantilever. This all depends on hoistway size. Assuming there...

We also have one of these machines. Has anybody noticed the motor coupling between motor and brake drum move back n forth about 3/8 inch? Is this norm...

Thanks I'll check them out