Elevator Forum

Buy on amazon the new OTIS tool it’s unlocked. It’s ends in AK3. This tool will Tell you a lot more then generic faults OTIS has many faults menus. OC...

Did you get the info you needed yet

Z coil is an output the the i/O board in the controller... I think P5-4. Off the top of my head. You may need to replace the iobd board

Sounds like your UCM and UCMX. Relay might have an issue. Or I/O board. Try and toggle UCM and UCMX off and on do you have a rope gripper?

Check wire A1 and A2. On BP relay. Sometimes there loose from all the wires being in the way. Will it try to run?

Have you changed EFO-P to 1 then blue enter. Then clear ram m-1-5-1. Then tried it?

It should be right after EFO-P.... do you have a blue tool that is unlocked?

M 1-3-1--6 on tool which is emergency, then go on 26 times to EFO-P landing 1-64 is front doors landing 101-164 is rear doors landings 201-264 is bo...

Been Working out of the Nashville area for years, ATL is screaming for help, Good area i know a few friends from there work is always steady and COL i...

Don't let your company bid on an elevator, BC "they think they can work on it" Just Sayin'

Update!!!! the Elevator was flickering in and out of group, from normal to OoG, But its fixed now had a communication issue between both cars and Grou...

Check and make sure your sensors are clean and dont have hoistway junk and dust. run the car down an inspection and make sure NTB goes lower case IN (...

that code is listed here on this pic; there has to be another issue Attachments code 0058-1.jpg (321.09 KB, 51 downloads)

Send us a picture of the controller I may be able to help, Im thinking its a 2815 DBD Fault