Elevator Forum

Carlos Silva Will supply parts, but you will probably need to replace the CPU board if you do not have the access code

Usually think of a random 4 figure number and double it from my experience of salesmen

Should have a DMR for the car and PLR at each landing

Check your PLR and DMR modules are communicating with the main board (steady flashing LED)

These are getting rarer than hens teethYou may need to get the old silly scope out and a test card for driveonce set up they run great but can be righ...

1 Run the elevator to the bottom floor. Give call from LCECPU user interface.2 Turn the elevator to RDF drive from switch 270.3 Use the RDF drive for ...

16.1.3 Setup drive (5 _2 _ 1)Step Action Note1 Ensure that the elevator is in RDF.2 Position the car with RDF so that LEDs 61U, 30 or B30 (or both), 7...

Easy after reading the write up lol

You will find a good thread on one of the European elevator forums I think the guy who posted was in the US

If you upgrade the software you will find the menus will become restricted If you are not Schindler don't let them upgrade the software or next time y...

Does the code 97 come up when the system is reset??if so it is a status code and one that does not seem to been in the European manualTo read the faul...

Its the monitoring circuit check NC on main relays, brake switches and the UCM solenoid mounted on the govenor is the one that usually plays up

Stannah sell thousands of these things may be worth giving the USA mob a ring Call toll-free 1 800 877 8247

Pre LCE KONE diagrams i find the easiest to follow

You can find CADI on the net if you look hard enoughBut some of the later software versions you need the SPECI tool or whatever app it is they run on ...