Elevator Forum

Look at the diagrams and make you own! I have done this a couple of times

We have the same problems this side of the pond with Schindler software updates so we tend not to do them! i think you may need the closed protocol Ip...

Yes, i have had many a training session with Paul. I think he still does a bit mainly for TKE and is enjoying his caravan on the South Devon Coast

It will be the opto isolators on the input from the safety circuit 10 locks the newer boards came with plug in opto's but if you have an older board t...

CF 15 i think

Either Buy the SAS system from Schindler or contact MODUSYSTEM and replace the COP with standard buttons using their driver board then you can do what...

Take off the COP and find input X-KEY then use relay from card reader to input signal and assign to a floor in parameters

Just wire your card reader relay into the key switch on the cop and set it to a floor in the paremeters

Don't use any additive with these units as it will coat the resistor in the valve and cause problems

www.modusystem.nl/en/products/modu-toolalways evolving due to modular design as new software is cracked it can just be added to your original tool I h...

Go for it!These units are ok once you get used to them, all spares are available to anyone in Europe Buy a Modutool to unlock all the parameters and a...

The zero point is pretty critical on these But as Alex says get the iWin software for a better view

Wow 28000 views someone should stick an add up here, you would get some great exposure 🙂