Elevator Forum

They have a tool that plugs in to it. I have not heard of someone with a laptop yet. If you need the tool I can help.

Update on this one....Access electronics was able to replace the driver chips since those are readily available. They were not able to verify operatio...

I am curious of how it dropped 84 floors and nobody got seriously hurt.

It's on the black market tk does not sell it

Cons 36 and 37 are not used. Thanks for taking the time to look at that. It does appear that the spots on the chips are burned on the 24 volt side In ...

I got a 70 and a 77 print. I used to have your email. If you want these two prints send me your email.

They want $1,000 for prints. This is a plc 1999 hydro. Not that complicated, we could muddle our way through it if needed. Sure would be nice if someo...

And you are correct it has a label on it that says ESI and the job number. I would have not thought of them. Thanks Abe

You have to have IMS

z44 would be the first thing. We had this issue not to long ago and posted on here. It was z44

Smartrise would answer that my two cents if u r going to mod the controller get rid of all of that expensive Kone stuff

Update on this one. After cleaning strainers it went down again. One of the guys increased the run monitor time a little. Has not faulted out yet.

Went by this morning to check selector wiring etc. It was one inch below top floor and had not releveled. No faults and it answered the call. When it ...