Elevator Forum

No not that i can remember. Seems like it had a 12 volt and a 5 volt output? Hate to beat a dead horse, but if you cant mod it or replace the operator...

Access electronics can repair the board. Copy the software first. We had one a while back that would fault out with an over torque at one floor, and i...

Those guys have pretty good tech support

There should be DCL and DOL. Check you gate hanger rollers and you will see the magnets. The cigar switches are at the either end of the travel for th...

He has passed on to the Great Machine Room(he would not be in the MRL shaft) in the sky.

Prints are HS Miprom 21 SWEO 90V Drawing number is WD-18103

Sorry about that......Miprom 21. I will get that info and send back to you. Thanks again.

Thanks bunches. Will be trying this out on the next one.

6300aar1 is $1,100 IDWT will the 6300aar1 work with any of the existing door dover boards?If that works it would be a big time saver. We have been swa...

I did reach out to the modu folks. I did not get a good feeling that their tool supports the North America version of the 3300. Anyone have one in Nor...

World Electronics

We were getting our solid state units from World Electronics. There was bad batch for a while, but we have not had that issue in a while. If you do fi...

the original host/forums/u...amp;Main=3647&Number=22778#Post22778Might be worth a shot, we had this weird issue a while back. Replaced the cap and...