Elevator Forum

I kind of thought that it was I have to get manual on this unit and read up on adjustments.i also seem to remember they use to have a spring on the tr...

Had not seen the page, only manual I have is copied on my per computer what page ??I'll definitely look it up and read and pass on to our tec support ...

Dose hoist way scan complete save all sel parameters confirm .car levels in but will not take call door open buttons works ,CHS pops up in the CLC sta...

Back on job thanks indirtweteust for the print and info turns out to be the relay board defective changed out that problem went away can now do learn ...

So back on job seems as though I'm getting 26 vdc. Feed thru traveler to IN stud T1 9-10 in controller relay board that's picking relay IN. Remove tra...

I got it so IN in controller relay has to be out thats what I thought. And we did replace the top of car inspection switch but just on /off switch not...

So today changed out all limit tree switch's except one did not have but verified it was working.changed out top of car inspection switch ,changed out...

So oddly enough if I run the car up from ac out to uss1 get it away from floor off limits I can run normal on inspection up and down no relevel that o...

Yes exactly you can't even get out of floor while still holding up and enable car just runs down to floor level and generated fault CLC 020-003 .talk ...

Apparently not according to the print it's a black belt open loop operator