Elevator Forum

Job is in Concord pa ,our office is new town square pa

Thanks

So update found out this door operator is a black belt closed loop operator from what I'm hearing is you need the older Otis tool to reset door operat...

Also looking for blue tool wright up if anyone has it thanks

Yes if your have something that would be great.thx

So update on Galaxy job we replaced the 1036bn board and car took off right back in service ran for about half hours had doors out no faults . Then ba...

So no expansion boards ,will have to look for this 24v to confirm,went back today tried two additional selector boards now kicking out fault 005 pulle...

Yes weird that it levels back down it dose have IN on CLC status not sure at the time of relevel down but at lease I'm connecting the CHS car homing s...

So back on job with repaired CLC board installed was able to connect entered door parameters and saved no issue still need learn trip and door scan. G...

So I'll have to check on that compatibility not sure if current board is BP4 also changed out power supply I do have 5.1 to lcc11 and have it thru con...

So think I checked voltages on power supply they seem ok .Was your voltages dropping down from 5.1 intermittently or was that just set to low ?all oth...