Elevator Forum

So this is a c4 controller engineer and finally got back to me there was no wiring issues the problem was apparently there's some type of bug in the s...

Found the info I needed although could use MPH 1 prints if anyone has them thx Attachments image001.png (195.03 KB, 34 downloads)

Thanks for the info

Thanks I'll look when I get back there how do u clear faults do not have that version write up TIA

so possibly bad encoder?

So this drive does not have KET-O magnetic open limit must do it Thur the encoder I would guess.

No this is the Otis GC global control unit,I've heard it called the hydro fit.just looking for fault codes and parameters adjustments and block diagra...

Send me your email I think I have them

Thanks again any info I get would be appreciated [email protected] Last edited by Robert H Schmidt; 07/24/23 11:49 AM.