Elevator Forum

Hey green pants, I had to go to this job today for same problem, only lasted one day this time, I pulled boards and removed all carbon like u suggeste...

Does the ims software interface with all T series Dover cars? TII TII,etc I've never used the software but I was under the assumption it was only for ...

I worked on a couple of these units about 15 years ago, I thought they were obsolete then, was surprised to see this controller still in existence. If...

Finally went to check on this job, the mechanic swears both cars did the same thing, however when I was testing the situation, I could not get the car...

If you happen to be servicing one of these units and your not sure if the battery will hold the memory while powering down, here is a tip. Open cop to...

No it is not a 104 board. That's an easy one. Vince is right there is a procedure to learn the door open limit without the tool which is what I did, i...

If your changing a Dover I series valve just install a jumper from MS to USS1 which would effectively jump out the FST N/C 1-9 contact

I had one like this a few years ago, while troubleshooting another problem I noticed the car would run up without any valve coils energized, I did not...

I found the board at world electronics. They call it a Mac marathon board. They also have a interface tool. Looks like they don't have a learn operati...

the mechanic didnt have a svt, I believe he says that he gets in to the car at the next to top landing and turns on normal and the car runs, didnt say...

yes thats the one, I know it has worked before because i have worked on them, the mechanic called today and notified me that both cars do the same thi...