Elevator Forum

On that last post, if you add oil additive for a tight packing it will change the viscosity of the oil. If bypassed is not set correctly you will get ...

Side slide or C/O doors. What type of door operator...

If you need to go into the ETSL full speed you can always jump out your normal terminal slowdown, which would be G24 to NTST and G24 to DLT. Those act...

From looking at the print it looks like you can take term. TSL1 (con3-5 on 188 E board)and TSL2 (con3-6 on 188E board) to G24 to simulate ETSL. There ...

what about the freq of the motor? was it less than 60hz?

w/ the ascension 2000 you can use any eeprom programmer like pocket programmer 3 from transtronics. the only way to get a no maint. prom is for a your...

yes you can use the UIT to create whatever door profile pattern you want for the specific job.

you can use the service tool connected to the tac20 controller via port RS232 to comm. w/ the hd-98 door op only. for the LD-03 and HD-03 door op you ...