Elevator Forum

First, Do you have a current loop Adapter to plug into TMS 600 Display Board to access faults or are you just seeing this led fault on the display boa...

What are you using to look at fault? I believe that is a very small transformer in the back of the controller. Don't remember the name but it always c...

Your asking for copyrighted info and Otis has tons of lawyers on retainer looking to pounce on some poor guy giving out info. Be careful and ask for s...

If you think it's traction slow your acel/deceleration rates and see it that helps. If problem goes away then you know it's a traction problem. Is the...

What operating system you using and if you go into Device Manager (Location depending on OS) what serial ports does it show? Also make sure your IMS w...

What kind of Machine is it? I know it's not a KONE, because they slip when their not supposed too. Even the 2 to 1's slip.

You clear faults and are cycling power when you change a board?

Make sure door reversal device is not firing cancelling door time. Some of the older stuff did not wait till door was open to cancel door time.

PM me an email will send you something. Most of these boards are Allen Bradly and are obsolete. Repair Only, don't throw any of them away. Tachs go ba...

21=EEPROM Read / Write Error�This will prevent the car from operating. Verify the content of PAR,FCP parameters with the FAST tool.Parameter out of ra...

well tried to post it did not go through Last edited by Rolly; 10/18/16 03:21 PM.

As far as I know they still do not come with a low movement micro like they should. The Finns are stubborn.

Menu 4-1 = Elev modeMenu 4-10 =Cpu SoftwareMenu 4-12 = User interface menu number.Anytime you change software version, you must do a 1-99 and reboot a...

Also try holding right button and see what motion mode says.

Should have changed all the brake micro's to low movement Micro's.Brake Micro switch for MX MachinesMfr Part#Omron Z-15HD-BMicro has short stroke trip...