Elevator Forum

Check the Non-Stop circuit. Depending on print number NS of NO. Controlled by a load weighing switch!

BOMA should have kept closer watch on what the code officials there are doing. Pretty sure the code requires special software or a PLC addition. The P...

Type off tag is what you need.

What is the controller number and wiring diagram on the controller tag? The tag could possibly be on a controller metal cover. Hope it did not get thr...

There is a software program for laptop called HHT. Works great!!

Post in Technical Questions, Better response!

If this is a 561 CPU (Has an SD Card Slot to load Software) It is probably a network messaging fault. Simplex or Multi car group?

I have the manual for Millar and the DC300 drive. Also have a hand held tool for the drive. Power supplies go out on the drive with ripple. Causes lot...

PM me an email

Try Posting in Technical Questions. May get better response. This section is for waiting for employment.

It is the Miprom 21 service tool and has to to lon..

BTW the ST strands for Serial Traction!

Those units are half Kone and Half Montgomery. You need Kone LCE info plus a Miprom Svc Tool to do many functions. This was a product when Kone first ...

Car Fault: 1085Fault Description:TAC50-04/32bit - An SPI Error has been detected on a CN or HN Node.Possible Causes:For hall nodes - Use the DHN(F/R) ...

Car Fault: 1084Fault Description:Car is too far out of level for a Relevel - Homelift requires a BP zone.Possible Causes:An invalid configuration or a...