Elevator Forum

I totally agree with pieman the problem is with the fault 401 you have to check brake switches can you tell which drive is installed?

it depends on the speed and load , all of gen2comfort which comes from Spain with 1m/s and loads up to 630kg comes without brake switches

I have sent my no.

if the problem is from brake switched it will give BS1-BS2 fault, and not all gen2 have brake switches.

CAN YOU TELL WHICH CONTROLLER BOARD YOU USEGECB I OR GECB II OR TCBC if you have the service tool (AND THE CONTROLLER IS GECB II) , when you connect i...

check level and slow speed magnets at top floor then you have to make learn run Last edited by rami410; 03/20/17 10:30 AM.