Elevator Forum

We tried to get a drive replacement and I was told by my office that we got ghosted by Kone. We told our customer to contact Kone directly.It appears ...

The were almost no help at all.Should say "the prints were"

After reinstalling the same software. I ended up with a single selector fault that would shut the elevator down for a few minutes while leveling to th...

At this point I'm looking for software. I suspect there may be an issue with the version I have since I reinstalled twice and already went through all...

After reinstalling software, I'm getting 3 faults. 1926, 2755 and 2757. If anyone has a good idea, I would appreciate the help.

The 1530 fault did not show up. Got 7 faults but was still running Monday morning. 2709, 1021, 2055, 1021, 2757, 2755 and 1926. Going to try reinstall...

Came back Saturday, since I was concerned about overheating. Apparently M13=60 is actually 6 seconds. Set it to 300 and got 30 seconds.Anyway, I found...

Thanks, I have it running now, hoping it will fault over weekend.

Found it. The were almost no help at all. There is a 1A Pico fuse about an inch away from the con-604, it reads about 12vdc to ground from both sides,...

It's on page 14 of the correct prints for this elevator. Everything is connected to the CWIG board, but I am having trouble locating all the connectio...

I think your missing the point where it works properly if you only turn the 110 AC to the lights off. The problem I am working on, occurs when the mai...

Forgot to say I had changed the battery, tried it on the second unit as well. Made no difference. Did not change the battery on the third unit at anot...