Elevator Forum

I have cut out and soldered in replacement batteries on these boards.it is a 2.4 volt battery.I got it from interstate batteries part no NIC1410 its n...

why do you have a list of all the elevators in Massachusetts and you don't know what a "K"is??? But to answer your question it stands for a stage lift...

2 Questions will the car run on inspection.And have you replaced the CIO board in the car station?

I have never seen a two stop DMC that was a selector board.Have never had to do a selector scan on a two stop just reset door timers

PAYNE basement drum 5stops sliding gate with swing doors installed early 30's

extra info 01=KET-Oand KET-s are active at the same time did an open or close limit get damaged?

green sleeves the only U15 chip I am familiar with is in the swing panel on a MCE,these people had alot of choices on elevator venders.They bought it ...

danzeitzs response to your question is spot on pull that sheave out and just send to Titan machine have done a few myself.The one thing not mentioned ...

I had this very problem it was a faulty 3 pole toggle switch at the bottom of car station I think door power supply goes through switch.I have seen ma...

You may want to check if the car is breaking traction coming into the top floor.The weights may be overhauling the cab.I had the same problem with the...

Connecticut New Hampshire Vermont all have licensing laws

Is there any chance that a problem with load weighing would cause this problem

I think you may want to try tweaking UA adjuster

I have had these key switches not work when key is turned all they way to the down I have jobs were you have to slowly turn key back until contacts ma...