Elevator Forum

722 is a drive fault check all aux contact in all drive relays maybe Pvec board is bad

probably a ghost that is the preferred time;)go to the building at that time, connect your tool to the elevator and check the Status Last edited by...

J19,20,22,241 car with jumpers , 1 car without j.....try (normaly the car with 1 cable in link 4 (P7 & P8) is the last or End of comunication remo...

maybe is 1 EFO (EFO emergency fire service phase 1)

I do not know if that version is new or very old but I can not find that code, where you found this code?

thnks

in the Print, has a Hall Call page,that page say the config

MOP, UA and DA must be off at the time of LUD in

PM

any Status in Car Disgnostic ?

Miconic HX (the H is for Hydro)is no HX traction 0036 No Start Ok Summary This section describes the Travel Control error No Start Ok. Description The...

nop is not montg.

Drive Field board !!! check jumper and config