Elevator Forum

What's the customer going to do when calling Kone? Do they have to prove they are a customer? What is DTMF?

How do you change the location message?

Does this job have a safety edge also? If so, then I would say your safety edge is retracting too far at final close and at full open and actually tri...

I have gone through the same as you. Just easier to use serial db9 computers for dmc1 pc at this time.

I have been trying the usb to 485 as well. Only works with serial db9 and "orange cable". I picked up a usb to 485 adapter plus orange cable, but not ...

All working. Needed password 6301 to get in and change. No jumpers for these movfe. Just params. Maybe the movfr has a jumper. I'll find out when I do...

You have to set parameter 15 from zero to 6301. Then parameter 11 is visible. 🙄. Hidden secrets.

Thanks. I pretty much ruled out the setup switch not working as I had to put it on setup to allow default centre opening parameters to be written to t...