Elevator Forum

Hi, I was told on the DMC you have to turn on a parameter to enable save mode. Not sure if that is true or not. Any one know?

I have a simplex hydro 2 stop 1994. If want give me you email.

Hi, is your LRU input high for level up should be off is not in level up vane? Does computer know it's in the leveling Zone by have LEV high and SU an...

There is a few chips on the backplane, what are the function of those chips? I know for normal service AESP output has to be high. AESS input accordin...

Done that but same issue persist.

this is a 2stop hydro, bottom is the fire floor with fire switch. Top just have hall button. No wires on AESH. Made ESB high car stop fire light and b...

Made ESB,ESS and AESS high with ESH low(I think this is phase 1 key input) the firelight still on at bottom landing with door open. Does any one know ...

beaupeep - setting up the I have to stop on my bottom normal and the car is about 1" below landing. The selector led stops blink at that time.Tarth - ...

Bottom floor is at that count. I had written the counts down before and all thw values match after learn trip.

The CLC board is new with new round battery as well as the power supply. At D4 diode voltage is at 3.75vdc and at the CLC chip is at 5.1 vdc. After th...

It runs normal, if anyone kill mainline the working value will go to zero.Can not seem to save the working values to memory.

That TS timer just delays the SAF relay to pick. I suspect MCE put that in to let the Comptuer load before letting the relays pick.

I want the little booklet on the side of drive that define the error lights.