Elevator Forum

Try here

Call Bart elevator service and ask for john at 1 (212) 239-1328. They make the cables.

Do you have the wizard program on a PC? If you do the button on the right thats looks like roll of film. Click the icon and follow the directions. It ...

Can you setup frame capture for that fault, see what I/O is missing.

On the side i see CRIPHNA 5.Q AThe squar chip has this labeled.590 960v 1.0EBLON 1/2.Q98-6-29Is that the numbers?

I think from left to right you have terminal 1then 2 . After that are the 25 (LD) 26 (lu) 27(dz) then the 70's. The triac is in the same order.

In the selector box if 71 light up then it's not the triac

Check in the print a lot of times STD/R0 is at terminal 71

You have certain access throw the CCU, the Manuel have details how to view the IOs

What is the star of emsd input?

Hi, Do you have all the modules in the controller have the steady green light? Is the car top box modules green light and the CTC board in the that bo...

Had a few of these for traction. Only have a generic print with no nomenclature, my usually issue is the resistor opens.

Have you set of the landing is a front or rear opening? Confirm how many landing is program.