Elevator Forum

Hi, controller looks like either OThompson, MG. If the resistor is in series with the brake coil usually is 150ohm 225watts 8 - 10". Wired to be a hol...

Update. Resolved issue by reseeding the square chip on the left behind the toggle switch and replacing the Drive 25pin cable with new cable provided b...

Hi and thank you for the suggestion. Had not change the serial cable yet but will be nextweek. All drive offsets has been recalibrate thru the softwar...

If you have the diagnosis monitor, F3 screen what are high light on the fault section. Also F7 screen will show detail of event log faults.

Job is in the process of MOD, car 1 has been cut out. What I mean "not AC" is no AC on the 5VDC supply. The dispactor 5VDC supply at time of frozen is...

Try LCD, Install as the PW

Hi, the serial number on the sensor would indicate which is needed. It’s either a NPN or PNP

Does the input for the brakes switch change?Is the handheld software version equal and higher than the CTRL chip version?

On the fault log find out which fault was first. Make sure in flight the LED on the relay board does not blink and verify the 110vdc is good. Make sur...

Hi, which motion are you working on? PTC or IMC series. Does problem occurred at the same area, both directions? Does car run normal on 2 floor runs, ...

HiDoes on have Brake switch? BLS is no high? You can set up frame capture on the wizard to catch the moment car faults out.

Got it ! STU sensor stuck in.