Elevator Forum

Is this on a LULA or a residential elevator?

8884mytags.com for safety test tags. Please let me know if there's a better/cheaper alternative. Seals and tags can get spendy.

Seals.com

I use emery cloth. I typically will go with 120 grit then 180 grit and finish off with 220 grit. It just depends how bad the joint/scratches are. I ta...

Chevron cylinder oil W 680 for most of my old stuff.

Oops. Haha

Call Texacone or Gorman. They might be able to help you. Post a picture of the jack if you can.

Call Texacone or Gorman. They might be able to help you. Post a picture of the jack if you can.

I use an Adams A701 two drawer classic style tool box and my helper brings in the cleaning/greasing bucket. I'll send my helper out to the van for any...

Ok, thank you slider. I'll get them from Vertical Express.

You might need a helper to run the car for you while you watch the up sequence of events on the failure. Have you ruled out the traveling cable?

I would go through the up leveling circuit with a fine tooth comb. What's it using for a selector? Year of install?

I had a DMC twinpost telescopic job a few years back that I found would stop about an 1/8" low at the top floor. I tried adjusting the top floor level...

Thank you guys.

Are the rollers mounted on the top end of the stationary piston?