Elevator Forum

Got it, thank you!

Nice!

Thank you UnkindBuffalo. Do you have the procedures to push it to the stop ring to test relief pressure?

I totally agree with you Alto101. They aren't my favorite to work on. They are very temperamental.

Conventional jack? Could you drill two holes in the top of each of your guide rails for shackles and sling the bolster channel on each side next to yo...

I just had a similar issue on a Saturday night call and found a bad pole on the 3 pole toggle switch in the COP. The car was doing some funky crap. Fo...

Sounds like a 4 hour plug-n-play job with a new $1500 circuit board. They could reproduce the old boards if they wanted to but then they would go out ...

Found the prints and documentation. The main line aux contacts were not wired up. Fixed the wiring, replaced the batteries and it works as it should.

Welcome!

Totally agree. My problems were simple if I would of had the full binary parameter adjustment sheets.

Dang dude. Probably how Smartrise was years ago. Have you installed an Alpha controller?

Welcome