Elevator Forum

Did you get the prints you were looking for? I have a set of DC prints I could send you.

Just had one of those repaired by MCE a couple months ago. $1900.00+/-. You'll have to call them and get a notification number, they won't do jack wit...

The F298 fuse is on the KDA module. Come to find out it feeds the drive power supply and the buss inside the drive. There wasn't a sub code for the 26...

I am only getting a 21 sub 2103 and a 26. I am blowing the F298-2 fuse and have a red and yellow lite on the drive I/O board blinking occasionally.

Send pics of the controller. How old is the Peele door controller? All relays or PLC?

Do you have the yellow hand held tool from ECI? (Florida not Canada) Will the doors open if you use the DOB after the car stops? Do the doors operate ...

Thanks Philly. Much appreciated. I will take you up on it.

Hey Philly. I asked our local Unitec rep about that and he either didn't know about it or doesn't have the info for it. Do you happen to have a part n...

I had reached out to Vertitron first about 4 years ago and then again about a year and a half ago. Both times I gave them the job number they said "ab...

I'm interested in them. Can you provide specifics? For what manufacturers? What types of equipment?

Typically that means there is a mismatch with the position of the directional limit switch compared to the magnets on the selector. When you are setup...

Sounds like your CPU defaulted. I had a similar issue a few months ago. Do you have the parameter sheets for the controller? Do you have a load weighi...