Elevator Forum

Johnny
@johnny
Honorable Member
Joined: Jan 1, 2010
Topics: 31 / Replies: 442
Reply

I am in the Pacific Northwest. Portland Oregon. Just as a thought, spin the encoder clockwise 20 or so revolutions and retry programing. Then spin ccw...

3 years ago
Reply

Did you try a different combination of buttons? I have set up a lot of these and never had that problem. You might want to have someone verify that bo...

3 years ago
Reply

The pendant doesn't override the safety circuit. Note that it has a switch on it that is inserted into the safety circuit. How tall is your floor??

3 years ago
Reply

Not if the cwt is hitting the floor, but to see if the car sling is hitting the floor under the car..

3 years ago
Reply

You could also pile some sawdust or kitty litter around the base of the rails to see if the counterweight is landing on the floor and slacking the cha...

3 years ago
Reply

That is the controller that TKE Access made for the LEV after they bought out Wheel-o-vator. The d fault is saying thet the safety circuit is open. Th...

3 years ago
Reply

when you get to the floor, whatever thee PI should show is what should register, At the bottom landing, it should show B at the second landing, it sho...

3 years ago
Reply

When you get to the third landing and press the two bottom buttons, does the display change, or does it stay at 1??

3 years ago
Reply

If it is a chain drive, you can release the brake and crank the car up by hand with either the wheel or an adjustable wrench.

3 years ago
Reply

Tx with no Rx is probably loss o communication

3 years ago
Reply

How are your floors marked? B 1 2 1 2 3 etc. Assumed that you have a jumper on the learn pins, yes?? The A and B lights are blinking when you run, the...

3 years ago
Reply

Where are you located MTNMAN? when you first turn the unit on with the cover off and the cover switch made up, what lights do you see on??

3 years ago
Reply

three wires are power, ground and data. I think the unit will run with only one hall station hooked up. You might try disconnecting one station at a t...

3 years ago
Reply

On some of those homelifts, They had a false floor below the elevator that stopped you from running down if it contacted something in its travels. I h...

3 years ago
Reply

The hall stations are not wireless. They are wired back to the machine. The voltaage on the cable is 24VDC to ground. Where are you located?

3 years ago
Page 6 / 32
Scroll to Top